CLIP-IN TILE REMOVAL
The method of
extracting Matador Clip-In tiles using the key tool is as follows:
- Establish the
direction of the spring tee. Where rectangular tiles are
used, the spring tee normally runs along the short sides of
the tile. For square tiles, the spring tee generally runs
lengthways down the room.
- Insert the key at a slight angle between the tile joints, approximately 50mm
from the tile corner, with the hook of the key facing the tile to be
- Push in the key until it touches the top of the spring tee section.
- Pull down the key against the top of the spring tee section and the tile
should start to come out. Repeat the process on the parallel corner
of the tile. Then the tile can be removed in a controlled manner.